On reset what happens in embedded system?

Question

I have a doubt regarding the reset due to power up:

1. As I know that microcontroller is hardwired to start with some particular memory location say 0000H on power up. At 0000h, whether interrupt service routine is written for reset(initialization of stack pointer and program counter etc) or the reset address is there at 0000h(say 7000) so that micro controller jumps at 7000 address and there initialization of stack and PC is written.

2. Who writes this reset service routine? Is it the manufacturer of microcontroller chip(Intel or microchip etc) or any programmer can change this reset service routine(For example, programmer changed the PC to 4000h from 7000h on power up reset resulting into the first instruction to be fetched from 4000 instead of 7000).

3. How the stack pointer and program counter are initialized to the respective initial addresses as on power up microcontroller is not in the state to put the address into stack pointer and program counter registers(there is no initialization done till reset service routine).

4. What should be the steps in the reset service routine considering all possibilities?

Answer 1

With reference to your numbering:

1. The hardware reset process is processor dependent and will be fully described in the data sheet or reference manual for the part, but your description is generally the case - different architectures may have subtle variations.

2. While some microcontrollers include a ROM based boot-loader that may contain start-up code, typically such bootloaders are only used to load code over a communications port, either to program flash memory directly or to load and execute a secondary bootloader to RAM that then programs flash memory. As far as C runtime start-up goes, this is either provided with the compiler/toolchain, or you write it yourself in assembler. Normally even when start-up code is provided by the compiler vendor, it is supplied as source to be assembled and linked with your application. The compiler vendor cannot always know things like memory map, SDRAM mapping and timing, or processor clock speed or what oscillator crystal is used in your hardware, so the start-up code will generally need customisation or extension through initialisation stubs that you must implement for your hardware.

3. On ARM Cortex-M devices in fact the initial PC and stack-pointer are in fact loaded by hardware, they are stored at the reset address and loaded on power-up. However in the general case you are right, the reset address either contains the start-up code or a vector to the start-up code, on pre-Cortex ARM architectures, the reset address actually contains a jump instruction rather than a true vector address. Either way, the start-up code for a C/C++ runtime must at least initialise the stack pointer, initialise static data, perform any necessary C library initialisation and jump to main(). In the case of C++ it must also execute the constructors of any global static objects before calling main().