ObjectDataSource created twice when control is changed

Question

I'm using an ObjectDataSource with a GridView with an OnObjectCreated handler on the code-behind. If I programmatically change a child control value on the GridView, the entire control gets databound a second time in the same request (as shown by the OnObjectCreated handler), which I don't want. This happens on the initial page GET request (so it is not a postback issue). Here's what a trace shows:

aspx.page   Begin PreRender
Custom      IN  handleDSObjectCreated() => tsDao: ETime.DAL.TimeSheetDAO    
Custom      OUT handleDSObjectCreated() 
Custom      IN  handleDSObjectCreated() => tsDao: ETime.DAL.TimeSheetDAO    
Custom      OUT handleDSObjectCreated() 
aspx.page   End PreRender

Is there a way to prevent the second round of databinding even if I manipulate the child controls? Nothing in the data layer changes so it is not needed. Note also there are no image urls involved which seem to cause double databinding too. Thanks.

Update:

I'm not sure if this helps or not, but in looking at the stack trace at the point at which the OnObjectCreated handler is called shows the following differences:

First Event Handler Invocation:

System.Web.dll!System.Web.UI.WebControls.GridView.DataBind() + 0x5 bytes
System.Web.dll!System.Web.UI.WebControls.BaseDataBoundControl.EnsureDataBound() + 0x53 bytes
System.Web.dll!System.Web.UI.WebControls.GridView.OnPreRender(System.EventArgs e = {System.EventArgs}) + 0x19 bytes
System.Web.dll!System.Web.UI.Control.PreRenderRecursiveInternal() + 0x57 bytes 

Second Event Handler Invocation:

System.Web.dll!System.Web.UI.WebControls.GridView.DataBind() + 0x5 bytes
System.Web.dll!System.Web.UI.WebControls.BaseDataBoundControl.EnsureDataBound() + 0x53 bytes    
System.Web.dll!System.Web.UI.WebControls.CompositeDataBoundControl.CreateChildControls() + 0x46 bytes
System.Web.dll!System.Web.UI.Control.EnsureChildControls() + 0x58 bytes
System.Web.dll!System.Web.UI.Control.PreRenderRecursiveInternal() + 0x33 bytes  

Again, this is all from the initial GET request. Any ideas why it's getting invoked twice?

Answer 1

Maybe you should use

if(!IsPostBack){
 //your code.
}

Is that you are looking for?